Hold Plate Manual

Installing the Hold Plate:

1. Align the mounting plate flush with the Doorway Mount.

2. Slowly slide it downward until the pins are fully seated and locked into the slots at the top of the Doorway Mount.

3. Confirm the following before proceeding:

  • The plate is flush with the doorway mount.
  • The pins are fully slid down and securely seated in their slots.

Attaching Climbing Holds:

The Hold Plate features pre-installed T-nuts, allowing you to easily attach climbing holds with standard 3/8"-16 bolts.

  • Use 3/8"-16 bolts only.

  • Make sure bolts are the correct length to fully engage the T-nut without bottoming out.

Do not overtighten. Tighten until the hold is snug and secure, but avoid stripping the T-nuts or damaging the hold.

Hold Compatibility Tips:

  • Most commercially available climbing holds will be compatible.

  • Test fit holds and bolts before using to ensure secure attachment.

  • Get proper length bolts based on thickness of the hold. The bolt needs to thread the t-nut securely without protruding out the back of the 3/4" Hold Plate.

⚠️IMPORTANT SAFETY NOTE:

Weight limit: 225 lb (102 kg)

Inspect the pins before every use. Ensure they are solidly in place and undamaged.

Also check that all holds are tight and stable before each session.